Plumbing needs to be done right! It can create more trouble and expense if it is not done properly! Not everyone is a plumber. If you are not up to the job, hire it out! If you can do-it-yourself, that is great! You will need the right tools and know how. Read this article for some handy tips and tricks!Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.
Use a hairdryer to thaw frozen pipes, after you shut off the water to the house. A hairdryer will gently heat the pipe and thaw the ice without causing significant damage to the pipe. Shutting off the water first means that if the pipe is broken, there will be no rush of water into the house.
If you have a clogged drain, don’t use cleaning chemicals to try to clear the clog. These harsh chemicals can corrode your metal pipes leading to leaks and broken pipes over time. Instead, stick to a plunger or make use of a plumbing snake to clear them.
Routinely check your appliance connections and faucets around the house for any kind of obvious leaks or nearby signs of moisture. Not only do even the smallest leaks lead to a large waste of water and money, they also can lead to damage to your home or even the development of harmful molds.
Watch how your toilets are flushing. If you have to jiggle the handle or if it takes too long, you might have to repair some toilet parts. Replacing these parts early may help you to save on your water bills and will save you from more expensive repairs at a later date.
When you wash your hands, be sure that you have not left any soap on the faucet handles. What people do not know is that leaving soap on these fixtures can cause fixtures to corrode. Just take two seconds after you are done washing your hands to remove excess soap from the handles.
Treating your drains every month is a great way to avoid future clogs and other problems, and it’s a very simple procedure. Just run one to two gallons of hot tap water down each drain in your house.
When you’re going away on a vacation, you should consider shutting off the water supply to your home. This can help stop many problems before they start. If you don’t do this, you should have someone stop by your house regularly to check that nothing has gone wrong and that your home isn’t flooded.
When searching for a good plumber you should always check references. It is easy to just go with the lowest price, but you have to do your research and make sure the plumber has a good reputation with the people they have done work for in the past so you do not get a bad plumber.
If you have a crack in your toilet tank, you can sometimes fix this with an epoxy resin. However, it is very difficult to keep up with this type of maintenance, and the best bet may be contacting the supplier and ordering a new tank to be installed in your bathroom. Nevertheless, keeping some epoxy resin on hand for emergencies is a good idea.
During the winter months, your water heater works the hardest. To keep it in optimum condition, flush it out before winter arrives. Flushing the system helps remove the sediment buildup, which causes internal corrosion of your water heater, shortens its lifespan, and reduces heating efficiency. Connect a hose to the faucet near the bottom of the tank and drain several gallons by directing the water into a nearby drain.
Be sure that you check on your water meter when it is not being used. Then, check on the meter 8 hours later. If the meter has changed, even a small amount, this could be a sign that there is an undetected water leak, which can be a severe problem.
If you are having any kind of problems with your water line or plumbing in general then you will first want to cut of your water supply. One of the most common mistakes that people make is to leave their water running while they are trying to fix things and this leads to bigger problems.
Make sure to never leave any flammable liquids near your water heater. Certain liquids like gasoline, solvents, or adhesives are flammable, and if left too close to the water heater, can ignite. If you have to have these liquids in your basement, place it far away from your water heater.
When getting an estimate from a contractor on a job, make sure to ask how long the written estimate is good for. For big jobs you usually want to get estimates from a few different plumbers. Knowing how long your estimate is valid will help you know what your time limit is for making a decision on who to hire.
Hopefully, you have found the tips and tricks above to be quite handy! Whether you hire out the job or do-it-yourself, take the necessary time to do it right. It can create more trouble and expense in the future, if it is not done properly!
Linden NC
