Plumbing 101: Tips And Tricks For Your Pipes

Well, you’ve decided to perfect the plumbing of your house. Good for you! However, there is so much information that you may not know where to begin. Don’t worry, plumbing tips are here! Listed below are some tips that will help you get started and organized, so that you can become a plumbing expert.

St. Stephens Plumbing Service NC

The next time you have a clogged drain, avoid the simple solution of dumping drain-clearing chemicals into the pipes. While this method involves the least amount of effort, the chemicals in these liquid cleaners are destructive to your piping. Instead, consider using a little bit of elbow grease with a plunger, snake, or other device designed to clear your clog without chemicals.

When starting a plumbing project that is due to loud noises in your pipes empty the pipes first. This can be an easy fix to an other wise wasted huge job. Just close the main water line and open the facets throughout the house. After the water has stopped flowing turn the water on from the main source and check to see if the noise is eliminated.

You need to winter-proof your house. You have to make sure you switch of the master circuit breaker or the shut-off valve before you leave your house. Since one small hole or congested water can quickly freeze and cause pipes to break and expand, you need to drain and open all outdoor and household water lines.

If you have bad water pressure in the shower, the showerhead might be clogged. Take a plastic baggie, fill it with regular vinegar, and tie it to the showerhead so that the showerhead is covered. Leave it overnight. In the morning, take the baggie off and use a small toothbrush to scrub away any mineral deposits.

If your sink is letting rusty water out and it will not drain, it is mostly likely because of the biological scum and grease that is built up in the pipes. You need to have your drains professionally cleaned, allowing maximum flow through your drains. Your drains must be open completely.

Before you can fix a toilet that does not flush properly, it is important that you find out what is causing the problem. Depending on what the problem is, you may be able to fix it yourself. However, more complicated toilet flushing problems may require the services of a plumber.

Sometimes low pressure in water lines can be fixed just by cleaning sediment out of the aerator. Disassemble the fixture to remove the aerator, and then scrub it with vinegar and a small brush. Wash it off, put it back together and connect the aerator to the faucet. Clean the aerator, it might increase your water pressure.

Clean out plugs can be extremely tricky to remove; they tend to stick easily. Here are two ways you can use to deal with a stubborn plug. First, try using a chisel with a hammer to get the fitting loosened. Your only other choice is chiseling directly through the actual plug itself.

If sewage is backed up in your toilet, it’s most likely the result of a sever blockage of the branch line that connects the sewage line and main line. If you are not able to remove the blockage, you need to contact a professional to snake the line clear.

You need to make sure outside faucets are covered and not dripping as winter approaches. If there are problems, you must make the needed fixes prior to the arrival of freezing temperatures. Freezing water can and will crack pipes, whether they are made of copper, steel, or plastic. Even a tiny crack can leak enough water to flood your home.

Be sure that you check on your water meter when it is not being used. Then, check on the meter 8 hours later. If the meter has changed, even a small amount, this could be a sign that there is an undetected water leak, which can be a severe problem.

Keep an eye on your monthly water bill to catch plumbing problems. Has your water bill gone up recently, even though nothing’s changed? This could indicate a water leak or appliance problem somewhere inside or outside of your home. Check under sinks for rusted pipes, look for water puddles under outside faucets, and consider having a plumber come out to listen to your pipes to detect running water.

A water heater that has no tank is a good choice for those that are conservation-minded. They don’t need to hold water in a reserve, instead they heat it as it passes through on an as-needed basis. This reduces the amount of energy they use, since water is only heated when it is called for.

If you need plumbing fixtures, think seriously about brass. Brass withstands extreme hot and cold temperatures and inhibits bacteria growth. Also, the brass fixtures in general look nicer than their counterparts. You can find these in stores, like Home Depot and Lowe’s.

Do not put stringy or fibrous items into your garbage disposal. Substances like banana peels, gristle, or celery may not completely break down in the disposal, and may clog your pipes instead of flowing out of the waste lines as they are supposed to. When in doubt, do not try to dispose of something that may not break down completely.

You should feel better after reading those tips when it comes to plumbing. That was a lot to read through, but at least you should have an idea of what to do and where to begin with your home’s plumbing. Besides, you can always come back to this list if you need to.

 

St. Stephens Plumbing Service NC

St. Stephens NC