Ready to make plumbing work for you? Great, time to get started! Wait, how do you do that and how do you get started? Never fear, here are some plumbing tips! This collection of advice should provide you with just the right amount of knowledge and inspiration to do your own plumbing.
Ensure that everyone in your household knows how to turn off the main water supply, or knows how to contact someone who can. In the event of a burst pipe or other water-related emergency, you should immediately turn off the water to prevent flooding, structural damage, and a sky-high water bill.
To prevent the pipes from freezing, it is advisable to seal off air vents, cracks and access doors. In order to keep the heat in and the cold out, you can try using insulation or caulk. In the event a leak occurs, make it a point to remind everyone where the master circuit breaker is so it can be shut off immediately.
When starting a plumbing project that is due to loud noises in your pipes empty the pipes first. This can be an easy fix to an other wise wasted huge job. Just close the main water line and open the facets throughout the house. After the water has stopped flowing turn the water on from the main source and check to see if the noise is eliminated.
Check how well your toilets are flushing. If the handle needs to be played with in order to keep the water from running constantly, or if it needs to be held down several times in order to flush, you may need to switch out some of the parts in your tank. This is not expensive, and it could help reduce your monthly water bill. It could also mean that you avoid the embarrassment of the flushing system breaking when you have visitors!
Make sure you clean out overflow holes in your kitchen and bathroom sinks on a regular basis. These holes are intended to act as an emergency fail-safe to prevent spillage from a full sink, but if they are clogged they can’t do their job. You can clean out an overflow hole using the same techniques you would for a clogged drain.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
To avoid sediment buildup, drain gallons of water from your water heater to flush any corrosion. This will help your heater to run more efficiently therefore saving you regular energy costs. Make sure to read your heater’s instructions before attempting this, and do this periodically to make sure that your heater is running as well as it can.
To lessen the chances of toilet problems, do not use as a place to put trash. Avoid flushing pads, cotton, towels, tissues or anything that cannot dissolve easily to avoid plugging the pipes. Even keep toilet paper use to the minimum necessary.
Sometimes you have to make the choice between replacing or repairing. If you have an old appliance, that uses a lot of water or electricity, it may be best to replace. Sure, it will cost more initially, but it will save you money in the long run. The other thing is, you can’t be sure how well a repair will work out, whereas with a new appliance you’ll at least get a guarantee.
Prevention is the key to keeping your plumbing repair bills down. One of the major repairs is clogs. This is because pipes can retain and trap hair, and other particles, very easily. Put drain covers over your bathtub and sink drains to keep loose hair from going down the drain or into your pipes. It is easy to get the hair out of a screen; however, removing it from a pipe is a different story.
Do not be surprised if a plumber charges you more than you expected. Many customers think that fixing a toilet or other drainage problem should be easy, therefore the price should be low. You must remember that not only does a plumber have to charge for labor, but they have to charge for parts that you need.
Now is the perfect chance to make plumbing work for you! Don’t worry; it can be personally tailored for just your home. After reading these previous tips, you should have seen that techniques and equipment are numerous and that anyone can can apply them to their plumbing jobs. It just takes research and experimentation.
Sparta NC
